1, all water is in contact with the resin, the use of high water, this paper mentioned in the "water" are referring to high water. 
 2, the "high water" means resistivity greater than or equal 10MΩ.cm, as low as possible in the TOC, 30ppb or so or less. 
 3, the resin is supplied, the hydrogen-type cation resin more than 99%. OH-type cation resin is greater than 95%, if the loading and operating properly in the first cycle that you can associate more than prepared resistivity less than 10ppb TOC 18.0MΩ.cm and pure water without regeneration chemicals. 
 4, in the storage and transportation process, all anion resin will produce some organic dissolved matter in order to ensure the initial operation cycle can be prepared by high water, requires filling resin to be very careful in the filling process of any ionic or my organic pollution will cause the resin contaminated, thus reducing the operating conditions, for this reason must ensure that all equipment used for loading operations and water will not contaminate the resin. 
 5, and the need to ensure that all the old container resin completely removed from the resin, the resin inside the container clean without foreign impurities. 
 Setup: 
 1, add water to resin, container, liquid level high 600-900mm. This is to cover the drainage system under the container, while preventing the installation of emission control by the resin resin impact nowadays. 
 2, the mixed bed resin into the container directly to the resin from the original bag or in the original containers joined to add some water into a slurry of water force the system into the resin container. Prohibit the use of resin transfer any mechanical pump, many types of pump will cause the resin will cause some damage or pollution, in the resin filling process, do not open at more than 2 bags of resin. This can minimize the time exposed to air, resin, resin, also the possibility of contamination of foreign matter down to a minimum. 
 3, resin filling, the resin should be fully immersed in water for at least 4 hours. If possible, the best soaked overnight. 
 4, the resin after the completion of the process of soaking in water, water began to wash the resin to eliminate the slightly anti-bubbles in the resin bed, we recommend washing flow rate of the anti-LV = 6m / h. 
 5, backwashing is complete, stop the backwash, the water began to discharge the container until the liquid from the resin bed at about the level of 150mm. 
 6, in washing before mixing with clean nitrogen resin, thoroughly mixed in the resin, the resin bed can be in the preparation of ultra-pure water.